Owner´s manual
DP-1
Manual version 10-11-2007
Connecting
When connecting the DP-1s, always connect ”+” and ”-” from the amplifier to the corresponding ”+”
and ”-” terminals on the DP-1 input. Connect your BassDirect speakers the same way to avoid phase
errors.
Spikes
After the initial placement of the speaker, you might consider using the supplied metal point spikes to give
themoptimalsupport.Tofixthemon,werecommendthatyougentlylaythespeakerononesideandscrew
in all four spikes together. Before you do this, however, be sure to place a couple of thick towels or similar
underneath the side of the speaker. This will prevent accidental scratching to the surface of the speaker.
After screwing in the spikes, gently bring the speaker to its vertical position. Once upright simply adjust the
spikestogiveoptimalsupport.Usingthespikeswillgivetheverybestsupportandsoundquality.Ifyouwant
to spare your floor surface from being punctured however, you can use the supplied rubber spikes instead.
Whichever option you choose, avoid “walking” the speakers if you need to move them to a different
position… especially on hard wood floors!
RoomPerfect
If you have a Lyngdorf product with RoomPerfect you can now run the program.
Cleaning
Please use a dust-free cloth to clean the speakers. It is also possible to use a slightly damp cloth for more
stubborn marks.
Under no circumstances should you use any kind of cleaning agent on, or in close proximity to, these
speakers.
Specifications
Product
DP-1
1” Soft Dome
6.5”
High frequency driver
Woofer/midrange driver
Crossover frequency
Frequency response
Sensitivity (2.83V/1m)
Nominal Impedance
2.2 kHz
300 - 22 kHz
89dB
4 Ohm
3
Technical Assistance
For latest version of this document please check the Lyngdorf Audio website.
If you have any problems with or questions regarding your Lyngdorf Audio product, please contact
your nearest Lyngdorf Audio representative or:
Lyngdorf Audio ApS
Denmark
E-mail: [email protected]
|